Precautions for safe operation of H-beam through type rust removal and cleaning equipment

Precautions for the operation of H-beam through type rust removal and cleaning equipment:

1. When operating the H-beam through type rust removal and cleaning equipment, it is necessary to have trained personnel carry out the operation. During the work, the operator should wear protective equipment to avoid personal injury caused by shot.

2. During the operation of the machine, it is strictly prohibited for anyone to stand on the running roller table.

3. During the operation of the H-beam through type rust removal and cleaning equipment, it is prohibited to open the observation door of the sealed warehouse at the inlet and outlet to check the operation of the workpiece.

4. Clean the shot material around the machine in a timely manner to prevent slipping and injuring people. Regularly open the dust removal pulse to remove dust from the shot blasting machine equipment. If the H-beam through type rust removal and cleaning equipment is not used for a long time, dust removal pulse back blowing should be carried out before the next use.

5. Smoking is prohibited in the operating area and the use of open flames is prohibited, as the H-shaped steel through rust removal and cleaning equipment generates high temperatures during operation, and the equipment contains combustible materials. If exposed to open flames, it can easily cause a fire.

6. The equipment is equipped with a red signal light. If there is an abnormal situation, it will make a sound. At this time, it is necessary to calm down and press the emergency stop button to stop the entire machine. Wait for the cause to be identified and the fault to be resolved before starting work. Technicians must cut off the power supply during maintenance and hang warning signs outside to indicate that someone is coming.

7. After the maintenance is completed, it is strictly prohibited to leave tools on chains, screws, etc. After that, it is necessary to carefully inspect them.

8. In case of sudden power outage, the main power supply should be immediately cut off to prevent accidents caused by incoming calls.